Forum Discussion

LTN's avatar
LTN
Icon for New Contributor rankNew Contributor
4 years ago

Cyclone10 GX: About Cyclone10GX Transceiver Native PHY.

Hi Intel, When I am learning to use SFP+ interface of Cyclone 10 GX board, I designed the project with ATXPLL IP core、Reset Controller IP Core 、Cyclone 10 GX Transceiver Native PHY, and connected t...
LTN's avatar
LTN
Icon for New Contributor rankNew Contributor
4 years ago

Hi @RichardTanSY_Altera,

There is my project in QuartusPro 17.1.

In this project, I enable the dynamic reconfiguration interface on the PHY, and set these interface like the example.

Then simulate the project in ModelsimStarterEdition.

The current problem remains that the tx_clkout and the rx_clkout signal is always 0.And after enable the reconfiguration interface,most of the signals are working in a wrong way now.

By the way, as you said,I post other question in a new case,why never recive any reply?

Regards,

Li.