Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
16 years ago

Quartus JTAG Programming Issue

Hey guys, I'm using the Max II CPLD (64 macros). After I program (using the Byteblaster II) the chip, Quartus says it finished and verified that the CPLD was programmed. However, when I look...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
16 years ago

--- Quote Start ---

Hey guys,

I'm using the Max II CPLD (64 macros). After I program (using the Byteblaster II) the chip, Quartus says it finished and verified that the CPLD was programmed. However, when I look at the signals from the chip on an oscilloscope, nothing has changed since I programmed it last (a few weeks ago). All I/O pins are assigned in my design and pin planner files. Can anyone maybe point me in the right direction?

Thanks,

Joe

--- Quote End ---

Hi Joe,

what kind of change do you expect ?

Kind regards

GPK