Forum Discussion

SteffenP's avatar
SteffenP
Icon for New Contributor rankNew Contributor
11 months ago

Quartus 25.1.1 Pro Fitter Error with Agilex3

Hi, I have an issue trying to compile Verilog project for a Agilex 3 (A3CZ135BB18AE7S) based development board. The error I'm getting is : Error (23098): One or more blocks are configured incorrec...
ShengN_altera's avatar
ShengN_altera
Icon for Super Contributor rankSuper Contributor
10 months ago

Hi,


If comment the tennm_ph2_ddio_out then the error will disappear. Could you replace tennm_ph2_ddio_out with gpio ip instead of direct using the tennm_ph2_ddio_out to prevent configuration error?


Thanks,

Regards,

Sheng


  • SteffenP's avatar
    SteffenP
    Icon for New Contributor rankNew Contributor
    10 months ago

    Hi Sheng,

    This is what I did in my last reply where I uploaded the Quartus Archive.

    Using the GPIO IP does *not* solve the issue.

    Cheers,

    Steffen