Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
11 years ago

Programming the Cyclone V GT development board

I'm working with the Cyclone V GT development board and have not yet been able to configure the FPGA via Quartus II. I'm quite new to FPGA programming, but I should say that I've successfully prog...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
11 years ago

Before trying to load a project you've built, load a file from one of the examples that came with the board. This will confirm that you have good hardware and your JTAG drivers are working. Next, try building the project and loading it to confirm that your Quartus installation is good. After that, make a small addition to the project to confirm that.