Forum Discussion

acremann's avatar
acremann
Icon for New Contributor rankNew Contributor
1 year ago

Programming of the CRAM of a Max10 using svf file

Dear all, We try to program the configuration RAM (CRAM) of a Max10 from an svf file. This works well, but in addition, something non-volatile is altered on the Max10 as well: a previous configurati...
Configuration
NurAiman_M_Intel's avatar
NurAiman_M_Intel
Icon for Super Contributor rankSuper Contributor
1 year ago

Hi,


Any update for this case?


Regards,

Aiman


acremann's avatar
acremann
Icon for New Contributor rankNew Contributor
1 year ago

Dear Aiman

I apologize for my late answer! Yes, the CRAM is programmed correctly, the design "Stopwatch" runs when I program the CRAM from my .svf file. However, when I do a Verify of the CFM0 using the programmer after powercycling the device, the contents of the CFM0 has been altered. Verify on the programmer using the pof file from the old design now shows an error.

Best regards,

Yves