Programming EP3C5E144C8N

after many reading of AN and other datasheet

I'll do that :

all my banks concerning configuration are at 3.3V

ep3c5e144c8n hasn't got a third MSEL so Fast POR is eliminated

so i'll connect the MSEL as following

MSEL[2]='0' / MSEL[1]='1' / MSEL[0]='0'

'0' = GND and '1'=Vcca so 2.5V

in addition to that, i'll add a 25Ohm resistor near EPCS in the connection between DATA(EPCS) and DATA0(FPGA)

and then i'll hope it will work

if someone can confirm me that, i'll kindly appreciate

thanks in advance