Forum Discussion
Altera_Forum
Honored Contributor
Honored ContributorProgramming Cyclone IV FPGA using USB Blaster Rev A
Hi, Is is possible to program Cyclone IV E FPGA with USB BLASTER Rev. A cable? I am facing "JTAG chain Broken error" when trying to program a custom board using JTAG interface. I am able to su...
Altera_ForumHonored Contributor
Honored ContributorOK, then there might be some problem in my board, as even though I can upload configuration data to EPCS memory the FPGA doesn't configures itself and CONFIG_DONE pin
remains LOW after power-up ( while nSTATUS is High ). The voltage distribution on my board is as follows: VCCIO ( All Banks ) = 3.3V VCCA = 2.5V VCCINT = 1.2V So far I can only suspect some broken track on the board, as schematic and PCB layout are according to Fig 8-28.
