Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
8 years ago

Problem with simulation and implementation of code in DE0 Nano Cyclone IV kit

Hi everyone, I have a kit DE0 Nano Cyclone IV EP4CE22F17C6, it has among other things 8 leds and I am programming in Quartus 12 and for simulate I am using ModelSim Starter 10.0d. My program generate...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
8 years ago

Hi Abenitez,

1. Check the pin assignments for led's and clock.

2. Use signal-tap and check the behavior of the outputs.

if you are getting the required waveform.

Then decreases the frequency so that the changes are visible at led's.

Best Regards,

Anand Raj Shankar

(This message was posted on behalf of Intel Corporation)