Forum Discussion

Honored Contributor

10 years ago

PLL error in BeMicro Max10 FPGA Evaluation Board

Hi All, I use BeMicro Max10 FPGA Evaluation Board. I need to verify the inbuilt ADC inside Max10. But I got following warning and error regarding the Avalon ALTPLL connected to the ADC. ...

SNigg1

New Contributor

7 years ago

Not helpfull since link is not working anymore

Forum Discussion

PLL error in BeMicro Max10 FPGA Evaluation Board

Recent Discussions

Bidirectional pin USB_RX with a pseudo-differential I/O standard must use the OEIN port of the node

Obsolescence issues

Avalon-ST configuration with Agilex 3 fails

Cyclone IV E – PLL Power Track Width Recommendation Clarification

JTAG Chain Broken on Agilex 7-I Dev Kit