Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
8 years ago

Pin matching issue on my Cyclone V GX Starter Kit

Hello everybody, I bought a Cyclone V Starter Kit (not the Development Kit) because I want to experiment digital electronics from simple logic gates and gradually the FPGA world. As I compile my d...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
8 years ago

--- Quote Start ---

The only thing I can think of is that you are not targeting the exact device on that board. Make sure the device in your project is set to 5CGXFC5C6F27C7N.

--- Quote End ---

Hey, it can't be real...I've switched to it...I've imported pin assignments from "default" project (they match with the manual) and now everything is OK. Thanks.

Now...I'm noticing that with programmer in JTAG mode, design goes away with the power-off of the board. What shall I do to load my design into the Cyclone?

Thanks again.