Forum Discussion

rahul7515's avatar
rahul7515
Icon for New Contributor rankNew Contributor
1 year ago

Pig tail connector of molex and amphenol for Stratix® V GX Transceiver Signal Integrity Development

i have the signal Integrity Transceiver development board stratix V GX edition and it has 1 molex 761605020 and amphenol JX40000682 backplane connector. Now i need to connect these to some other board which has SMA connector. i have searched on the internet and i don't see any direct backplane connector to SMA or its breakout board. so is there any pig tail pre crimped connector available for mating part of these connector.

Board Debug
Configuration
Other Ips

7 Replies

  • AqidAyman_Altera's avatar
    AqidAyman_Altera
    Icon for Regular Contributor rankRegular Contributor
    1 year ago

    Hello,


    From my knowledge, the development board supports a FMC front-panel expansion for connectivity via popular standards such as QSFP and SFP+. This low-pin count (LPC) FMC port (J8) connects to the FPGA1 device. This interface provides 10 transceiver channels with 10.3125 Gbps capability. The FMC interface supports both single-ended and differential signaling.


    Regards,

    Aqid


    • rahul7515's avatar
      rahul7515
      Icon for New Contributor rankNew Contributor
      1 year ago

      can you please provide the part number also the SFP+ connector is a single transceiver line i need mor. i need more number of connection that is why i am looking for backplane to SMA connection

  • AqidAyman_Altera's avatar
    AqidAyman_Altera
    Icon for Regular Contributor rankRegular Contributor
    1 year ago

    Do you have a chance to reach out to your local sales distributor for this request?


    • rahul7515's avatar
      rahul7515
      Icon for New Contributor rankNew Contributor
      1 year ago

      yes i do need help as i am unable to get any solution for this from any of my local vendor

  • AqidAyman_Altera's avatar
    AqidAyman_Altera
    Icon for Regular Contributor rankRegular Contributor
    1 year ago

    Hi,


    I try to reach out the internal team, but they can't help as they didn’t have much details on this. This is an old design from board team which was released many years ago.