Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
8 years ago

Need assistance with Setting up transceiver for C5G dev board

Hello all, I'm currently designing a basic BERT using the cyclone 5 gx dev board. The problem I'm having right now is that while I'm only getting time analysis warnings, the transmitters don't ...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
8 years ago

Just an update:

Fixed a couple odd wires I had going through the design (had RX_Cal going to a clock input instead of RX clock).

Still trying to get transmitter to actually send data. I used LEDs in the design to check to see what statuses are there. Both the TX and RX ready ports on the controller are good, but the transmitter is still sending nothing at all. This is confirmed using an optical power meter.

Any ideas, folks?