Forum Discussion

Honored Contributor

11 years ago

Multiplexing a clock signal in Cyclon III.

Hi All. I am designing a new project that will include selecting one of Twenty 125Mhz square wave clock signals, and measuring the frequency of the selected one. My plan is to insert all of ...

Altera_Forum

Honored Contributor

11 years ago

See Table 1-19 on page 1-14 in the cyclone iii device datasheet (http://www.altera.com/literature/hb/cyc3/cyc3_ciii52001.pdf). You should be fine at 125MHz.

Regards,

Alex

Forum Discussion

Multiplexing a clock signal in Cyclon III.

Recent Discussions

Cyclone 5 SoC FPGA Bank Supply Prerequisite

AGILEX 5 Migration issue

To INTEL - Request for Compliance Data from Analog Devices, Inc

Arria 10 GX RX max intra-differential pair skew

MAX10 Bitstreams Authentication