Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
16 years ago

modelsim: how to use parameter and error faced

It is pretty fine when i use QII to compile my design. However, when i use modelsim-starter edition, a lots of error popping out. Error: Identifier must be declared with a port mode: d. ...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
16 years ago

The 2 errors caused by 1 problem only. The placement of parameter should be put on top after the entity. what a silly mistake..

thanks