Migrating from Arria 10 to Stratix 10

Question

Hello,

I am working on updating a PCB board schematic, and migrating from Arria 10 to Stratix 10. Some questions that I have now:
Some pins seen on Arria 10 (like DEV_OE, DEV_CLRN, CRC_ERROR, ASDO, NCE, and NIO_PULLUP) can not be found on Stratix 10. What should I do? Can I simply remove connections to these pins in old design? Thanks,

Regards,

aqidayman_altera · Answer

Hello,Thank you for reaching out to Intel FPGA Community.For your information, migration pin support is available for the same device family within the same package.You may refer to this Migration Pinout - Intel CommunitiesRegards,Aqid Ayman

Forum Discussion

Migrating from Arria 10 to Stratix 10

1 Reply

Recent Discussions

DO-254 Cyclone10LP / CycloneV

Mac internal loopback F-Tile, Quartus 25.2

Question About MAX 10 Cryptographic Signing Support

Suggestion of carry chain type TDC of Cyclone 10 GX FPGA chips

Cyclone 10 LP Device Pin Match