Forum Discussion

Gigiz's avatar
Gigiz
Icon for New Contributor rankNew Contributor
4 years ago

MAX10M04 / Quartus Prime Lite Edition

Good morning, I'm completing a project with MAX10M04 FPGA and Quartus Prime 20.1 Lite Edition software. The project is in the final phase, everything works fine but I have a very strange problem: I...
Gigiz's avatar
Gigiz
Icon for New Contributor rankNew Contributor
4 years ago

Hi Nurina,

In attachment you have the warnings report, you can also compile my project and look it.

I try to look the documentation and simulate my project ...

Can you simulated my project ?

Best Regards,

Gigi

Gigiz's avatar
Gigiz
Icon for New Contributor rankNew Contributor
4 years ago

Hi Nurina,

I have not solve my problem yet, did you see the warnings report ?

Best Regards,

Gigi

  • Gigiz's avatar
    Gigiz
    Icon for New Contributor rankNew Contributor
    4 years ago

    Hi Nurina,

    my project running at 99.99%, I made a very simple modification...

    I attach the project, look at top level schematic "EtherCAT", you can see the signals "enc4_A" and "enc4_B" connected directly to ground.

    In this condition all counter works properly and all the project runs, I have only 2 signals not connect (but I use theese only for monitor).

    What can be the reason ?

    Thanks.

    Best Regards,

    Gigi