Forum Discussion

Gigiz's avatar
Gigiz
Icon for New Contributor rankNew Contributor
4 years ago

MAX10M04 / Quartus Prime Lite Edition

Good morning, I'm completing a project with MAX10M04 FPGA and Quartus Prime 20.1 Lite Edition software. The project is in the final phase, everything works fine but I have a very strange problem: I...
Nurina's avatar
Nurina
Icon for Regular Contributor rankRegular Contributor
4 years ago

Hi Gigi,


You can refer to page 3 of this document on how to use it: https://www.intel.cn/content/dam/altera-www/global/zh_CN/pdfs/literature/hb/qts/qts_qii51013.pdf


The Intel FPGA YouTube channel has some videos on it as well, you can start here: https://www.youtube.com/watch?v=nWIGG0eWpJU


Part 2 of the video lecture is available here: https://www.youtube.com/watch?v=gFclHedSomA


In most cases warning messages can be ignored. Can you attach a photo of the warning messages here so I can verify that it can be ignored?


Thanks,

Nurina


  • Gigiz's avatar
    Gigiz
    Icon for New Contributor rankNew Contributor
    4 years ago

    Hi Nurina,

    In attachment you have the warnings report, you can also compile my project and look it.

    I try to look the documentation and simulate my project ...

    Can you simulated my project ?

    Best Regards,

    Gigi

    • Gigiz's avatar
      Gigiz
      Icon for New Contributor rankNew Contributor
      4 years ago

      Hi Nurina,

      I have not solve my problem yet, did you see the warnings report ?

      Best Regards,

      Gigi

      • Gigiz's avatar
        Gigiz
        Icon for New Contributor rankNew Contributor
        4 years ago

        Hi Nurina,

        my project running at 99.99%, I made a very simple modification...

        I attach the project, look at top level schematic "EtherCAT", you can see the signals "enc4_A" and "enc4_B" connected directly to ground.

        In this condition all counter works properly and all the project runs, I have only 2 signals not connect (but I use theese only for monitor).

        What can be the reason ?

        Thanks.

        Best Regards,

        Gigi