MAX10/DE10-Lite accelerometer connection

Question

Good morning,

I would like to know if the I2C connection between the MAX10 and the accelerometer (ADXL345B) in the DE10-Lite board is implemented with additional series resistors for shortcircuit protection or only with the standard pull-up resistors. I have tried to figure out looking at the PCB, but it is not so simple.

The reason is that I am evaluating the board for being used in my classes and I want to know the degree of freedom I can reach with my students.

Regards,

altera_forum · Answer

I didn't try downloading it, but maybe the schematic is on the "DE-10 Lite CD-ROM" here:  http://www.terasic.com.tw/cgi-bin/page/archive.pl?language=english&amp;categoryno=234&amp;no=1021&amp;partno=4

Forum Discussion

MAX10/DE10-Lite accelerometer connection

1 Reply

Recent Discussions

Compatibility and Configuration of Arria10 Devices with and without HPS

USB Blaster conflicts with other FTDI devices result in PC crash

MAX10 Single end I/O low/high speed bank frequency

Device migration about DD and DA

USB2 blaster license