Forum Discussion
Nakaj
New Contributor
New ContributorMAX V Exposed pad solder reflow problem-2
Hi I have an additional question related to my previous question. Is there a standard for the contact area of the exposed PAD of MAXV QFP64 with the printed circuit board? For example, 50% or more...
AqidAyman_Altera
Regular Contributor
Regular ContributorHelllo Nakaj,
We don't really have the recommended percentage of contact area for the exposed PAD. I have confirmed this with the internal team.
However, they provide an article that is worth for you to look into as your reference. Refer below link:
https://www.allaboutcircuits.com/technical-articles/stencil-design-for-exposed-pad-packages/
Regards,
Aqid
- Nakaj
Hi Aqid,
Thank you for your reply.
I’m looking forward to hearing from you regarding your internal team discussion.
Regards,
Nakaj
