Forum Discussion

yss1's avatar
yss1
Icon for New Contributor rankNew Contributor
4 years ago

MAX® V CPLD (5M2210ZF256C4N)configure my Cyclone V GT FPGA

How on earth should I use MAX® V CPLD (5M2210ZF256C4N) to configure my Cyclone V GT FPGA (5CGTFD9E5F35C7N), showing that MAX® V CPLD does not allow me to use EPCQ, so how do I use flash
FakhrulA_altera's avatar
FakhrulA_altera
Icon for Regular Contributor rankRegular Contributor
4 years ago

Hi Yss1,


It is possible to configure the FPGA from the EPCQ device. However, the MAX V design provided with the Cyclone V GT FPGA development kit does not allow you to store a design in the EPCQ configuration device.


To enable FPGA configuration using the EPCQ device, reconfigure the MAX V device with the design file, you may refer to the following KDB document:


How do I access the EPCQ configuration device on the Cyclone® V GT FPGA Development Kit?


Thank you.


Regards,

Fakhrul