Forum Discussion
Altera_Forum
Honored Contributor
Honored ContributorLVDS resistor termination in Cyclone III
Hello, I have a design with 2 FPGA (EP3C16F484) linked together with a set of LVDS line. I use pins in bank 1, 2, 5 an 6. Should I place a 100ohms resistors on the receiver side, or is it i...
Altera_ForumHonored Contributor
Honored Contributor --- Quote Start --- Should I place a 100ohms resistors on the receiver side --- Quote End --- Yes. The hardware manual is clear about this point.
