Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
9 years ago

JTAG Programming successfull but no effect at the ouput

I am using a Cyclone III EP3C120F484 device for my custom board. When I connect the USB Blaster and run the JTAG programmer in Quartus, the programming is done with no error. The code is just writt...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
9 years ago

Yes i have checked that nCE pin is tied to GND and both CONF_DONE & nSTATUS pins are pulled up externally. But didn't find any result yet.

Mohsin