Forum Discussion

TNguy162's avatar
TNguy162
Icon for New Contributor rankNew Contributor
6 years ago

Issue of using F2H bridge on Arria 10 to access H2F_LW.

Hi everyone, I have an issue related to using F2H bridge to access registers on FPGA via H2F_LW bridge. As I read from the Arria 10 HPS technical reference manual, from the address table of page 37...
TNguy162's avatar
TNguy162
Icon for New Contributor rankNew Contributor
6 years ago

Hi el.ign,

Thanks for your reply.

I think the same. We ran simulation and tested on board. There is no problem so far but I'm just worried about meta-stability. That happens occasionally and hard to detect on board.

Best regards,

Joe

EBERLAZARE_I_Intel's avatar
EBERLAZARE_I_Intel
Icon for Regular Contributor rankRegular Contributor
6 years ago

Hi Joe,

Let me check for any information I could find and check with out internal team regarding this.

Best Regards.