Forum Discussion

Er7Cho1gU's avatar
Er7Cho1gU
Icon for New Contributor rankNew Contributor
3 years ago
Solved

Initial value setting error

Hello: I'm new in verilog. Hopping that it's not a very stupid problem. I'm tring to buid a FSM system using register "state" to perform the state now. There is no error hint or any fun...
  • ShengN_altera's avatar
    ShengN_altera
    3 years ago

    Hi,


    Try to use devices Cyclone III, Cyclone IV, Max II, Max V or Arria II instead of Cyclone V. New devices are not supported on vwf waveform simulator because this is legacy simulator which only supported legacy devices and mainly for university program purpose. Or may be you can use modelsim simulator instead of vwf waveform simulator.


    Best Regards,

    Sheng

    p/s: If any answer from the community or Intel Support are helpful, please feel free to give best answer or rate 4/5 survey.


ShengN_altera's avatar
ShengN_altera
Icon for Super Contributor rankSuper Contributor
3 years ago

Hi,


Try to use devices Cyclone III, Cyclone IV, Max II, Max V or Arria II instead of Cyclone V. New devices are not supported on vwf waveform simulator because this is legacy simulator which only supported legacy devices and mainly for university program purpose. Or may be you can use modelsim simulator instead of vwf waveform simulator.


Best Regards,

Sheng

p/s: If any answer from the community or Intel Support are helpful, please feel free to give best answer or rate 4/5 survey.


  • Er7Cho1gU's avatar
    Er7Cho1gU
    Icon for New Contributor rankNew Contributor
    3 years ago

    I understand. Thanks of the reply!!