Honored ContributorHi
I am using MAX II Micro Kit. In my application i need to use 32.768Mhz oscillator. Can i replace 50 Mhz oscillator with 32.768 Mhz? If i change it, will i have programming problems? how can i use different oscillator by MAX II Micro Kit? Thanks in advance
Honored ContributorI've never seen 32.768MHz oscillator, but if You found one, then there should be no problems. Check twice if it is not 32768kHz
Honored ContributorI replaced 50 MHz osc on board with 32.768 MHz. ( I checked again it is written 32.768 MHz. Anyway it is equal to 32768 kHz) I couldn't program the fpga. I don't know the problem. Do you have an idea?
Honored ContributorYou sure it's MHz, no kHz? Should work afaik.
Honored ContributorI attached the photo of my osc.
Honored ContributorReplacing 50 Mhz with 32.768 can be the problem??? or should i use my osc as an input?
Honored ContributorDid You check if the oscillator itself works? Using a scope ofcourse.
Honored ContributorYes, I did.
Honored ContributorThen I am out of ideas, sorry.
Honored ContributorThanks for your try :))
Honored ContributorI have "can't access jtag chain, error code 44" error, while i am trying to program. What does error code 44 mean?
