Forum Discussion

SHuai's avatar
SHuai
Icon for New Contributor rankNew Contributor
6 years ago

I have a problem with program. when i download a sof file with jtag,it successd in case of msel value 001(ps/fpp mode).But if msel set to 011(as mode),it fail,error ID:209014.

The chip is 10AS016E3F27. In ps/fpp mode,jtag detect 2 device,10AS016E3 and SOPVHPS In as mode,jtag detect 1 device,10AS016E3 I have connect nCONFIG,nSTATUS,CONF_DONE through a 10 k resistor to VC...
ShafiqY_Intel's avatar
ShafiqY_Intel
Icon for Frequent Contributor rankFrequent Contributor
6 years ago

Hi SHuai,

May I know the status of this issue?

Thanks

  • SHuai's avatar
    SHuai
    Icon for New Contributor rankNew Contributor
    6 years ago

    The problem has been solved.

    The hardware engineer made a mistake that there are differences between boards and schematic design.

    when I set msel value 011,actual setting is 101.It is a wrong configuration.

    Thanks​

    • ShafiqY_Intel's avatar
      ShafiqY_Intel
      Icon for Frequent Contributor rankFrequent Contributor
      6 years ago

      Hi SHuai,

      I am glad to hear that the issue is resolved.

      I will close this thread. If you have further question, please submit a new forum thread.

      Thanks