Forum Discussion

DRaja2's avatar
DRaja2
Icon for New Contributor rankNew Contributor
7 years ago

I get the "can't access JTAG server" error - Code 35, when trying to program my MAX10 FPGA.

I have the revB development kit. The kit was working fine for a really long time until it suddenly stopped being recognised by the Quartus programmer. The USB blasterII is recognised under my device ...
AnandRaj_S_Intel's avatar
AnandRaj_S_Intel
Icon for Regular Contributor rankRegular Contributor
7 years ago

Hi,

Good to know that board works with jtag header.

  1. If you are programming​ .pof we need to restart the board(power off and on) which will boot the image.
  2. Yes, embedded USB blaster chip or USB cable or Mini-USB connector or residuals forming bridge which may cause such problems.

Regards

Anand