Forum Discussion
Altera_Forum
Honored Contributor
Honored ContributorHow to keep fpga in low power mode
Hello people, Today i have another question :) My new fpga module (with EP3C25E144) will work only when it gets a command. does its job and waits for the next command. Because of my d...
Altera_ForumHonored Contributor
Honored ContributorI'm not sure stopping and restarting the oscillator will work very well, as it's output can be a bit erratic when it starts again and before it stabilises.
You can add clock enables to your design so that the registers only switch when the enable signal is active.
