Forum Discussion

ap_mercy's avatar
ap_mercy
Icon for New Contributor rankNew Contributor
4 years ago

How do I verify the data I send on the f2hps bridge on the Startix 10?

In my design I’m able to do master transfers to OCM(starting at address 0x00000000) and verify that data from the HPS by using the HPS2FPGA off set at (0x80000000). If I master the same data to the FGPA2HPS directly how can I verify this data? Which location in the HPS would I have to read?

3 Replies

  • aikeu's avatar
    aikeu
    Icon for Regular Contributor rankRegular Contributor
    4 years ago

    Hi ap_mercy,


    The OCM is on the FPGA side, sorry that I may not know understand correctly what you are trying to do.

    I think is not possble to master transfer your data to the FPGA2HPS directly and verify the data....

    Maybe you can share more details in a diagram in order to have a better picture.


    Thanks.

    Regards,

    Aik Eu


  • aikeu's avatar
    aikeu
    Icon for Regular Contributor rankRegular Contributor
    4 years ago

    Hi ap_mercy,


    I will close this thread if no further questions.


    Thanks.

    Regards,

    Aik Eu


  • aikeu's avatar
    aikeu
    Icon for Regular Contributor rankRegular Contributor
    4 years ago

    Hi ap_mercy,


    We do not receive any response from you to the previous question/reply/answer that I have provided. This thread will be transitioned to community support. If you have a new question, feel free to open a new thread to get the support from Intel experts. Otherwise, the community users will continue to help you on this thread. Thank you.


    Thanks.

    Regards,

    Aik Eu