Forum Discussion

JET60200's avatar
JET60200
Icon for Contributor rankContributor
5 years ago

how can “EPCQ“” Flash store both FPGA Image and customer user parameters ?

dear, our A10 GX board has an EPCQ1024L Flash, we can burn FPGA image into it and power up board to run it successfully. Now we have some customer parameters which needs to be stored on-board fl...
  • JET60200's avatar
    JET60200
    Icon for Contributor rankContributor
    5 years ago

    hi @NurAiman_M_Intel , thanks for reply,

    Even though we can boot up fpga from the serial flash device with a specified starting address, how can FPGA access (i.e read ) that "customer parameter partition" in serial flash when FPGA runs up ? Is there any exampe from FPGA side to read/write the serial flash ?

    WE need fpga to read customer parameters & data wich stored inside the serial flash //

    Thanks in adv