Forum Discussion

NKuma10's avatar
NKuma10
Icon for New Contributor rankNew Contributor
7 years ago

Hi All, I have some doubt regarding FPGA I/O banks.

I'm working on FPGA with I/O banks configured as 3.3-V LVCMOS with current strength of 2ma. I have a requirement to change the current strength to 16ma for some of the signals in this I/O bank which...
SreekumarR_G_Intel's avatar
SreekumarR_G_Intel
Icon for Frequent Contributor rankFrequent Contributor
7 years ago

Hello Naveen ,

Apologizes for delay ,I think you can use it as long as your voltage compatibility analysis (VIL/VIH and VOL/VOH) satisfy the requirement. Also make sure trough IBIS model you are getting sufficient current strength and check the signal integrity as well.

Thank you ,

Regards,

Sree