Forum Discussion

SnehalB's avatar
SnehalB
Icon for New Contributor rankNew Contributor
3 years ago

FPGA Reconfig fails from other address location in S25FL256L QSPI, but works at 0x000 for ota updat

Hi , We are trying to flash QSPI from FPGA with used logic code using Generic serial flash controller IP as OTA update. We are trying to flash two image IMAGE1 at 0x0000_0000 location & IMAGE2 a...
FakhrulA_altera's avatar
FakhrulA_altera
Icon for Regular Contributor rankRegular Contributor
3 years ago

Hi SnehalB,

Have you followed the criteria (Byte addressing, Dummy clock settings) of third-party configuration devices supported by Intel Quartus per table 3 below? You can refer in detail here Intel® Supported Configuration Devices

Regards,

Fakhrul