FPGA flash read command

Question

Hi, I have a question about SPI command used to read flash contents and I hope you can help me.
We are using Arria V 5AGXFB3H4 (5AGXFB3H4F35I3N).IP is located in flash.
I would like to know which SPI command with which parameters is used to retrieve flash contents?
Thank you.
Best regards,Jelena Mijatovic

ericmunyew_c_intel · Answer

Are you interfacing your flash with GSFI ?

Forum Discussion

FPGA flash read command

1 Reply

Recent Discussions

LTC Connector DE10-Standard FPGA

Does direct connection of two AXI4 Masters to DDR Slave support auto-arbitration on Agilex 5?

nSTATUS is sometimes asserted low during Agilex-F configuration when operating in PMBus slave mode

Agilex5 Engineering Silicon

Max10 Security Bit