Forum Discussion
Altera_Forum
Honored Contributor
Honored ContributorFPGA Development Board - strange shift operation behavior
My development board based on: Cyclone IV EP4CE10E22C8N Quartus: 17.0.0 Lite Edition top-level entity code:
module led4_reg(clk, led);
parameter BASE_LED_SEQUENCE = 12'b000011101101...
Altera_ForumHonored Contributor
Honored ContributorHi,
Is your board an Altera/terasic dev board or a custom one based on Cyclone IV ? If its the Altera/terasic one, then most likely the LEDs are all active low , meaning, a writing a '0' will turn ON the LED and '1' will turn OFF the LED.
