Forum Discussion

Amir3's avatar
Amir3
Icon for Occasional Contributor rankOccasional Contributor
4 years ago

FPGA configuration using FlashMemory that JIC file does not start from 0x00 start address- possible?

Hi, My FPGA device is Cyclone V - 5CEFA7U19I7. My Flash Memory device is MT25QL256ABA1EW7 (Micron). Will the FPGA config if the JIC file does not start from a 0x00 start address? Thanks.
YuanLi_S_Intel's avatar
YuanLi_S_Intel
Icon for Regular Contributor rankRegular Contributor
4 years ago

is all depending on your setting during JIC programming file generation. You can choose the start address.


  • Amir3's avatar
    Amir3
    Icon for Occasional Contributor rankOccasional Contributor
    4 years ago

    I know to set the start address when I create the JIC file.
    The question is did the FPGA know how to burn the architecture from the Flash when the JIC file does not start from 0x00?

    for example, the JIC file start address from 0x0020_0000.