Example of PC communication with Cyclone III Starter kit through virtual JTAG?

Question

Anyone has simple example of PC communication with Cyclone III Starter kit through virtual JTAG?

The control panel example come with Cyclone III Starter kit is decrypted and can not tailored to my use. Also it uses C/C++ program to communicate. I want to use Tcl.

I read some documents of virtual JTAG, not completely understand.

Thank you very much!

altera_forum · Answer

you might take a look at System Console  http://www.nioswiki.com/index.php?title=systemconsole

altera_forum · Answer

Thanks, but system console is not universal, it is for SOPC only. What if my code is not SOPC?

--- Quote Start ---

you might take a look at System Console

http://www.nioswiki.com/index.php?title=systemconsole

--- Quote End ---

altera_forum · Answer

any one has example of PC communication using JTAG UART without Nios II?  Thank you very much!

Forum Discussion

Example of PC communication with Cyclone III Starter kit through virtual JTAG?

3 Replies

Recent Discussions

Cyclone IV drop in replacement confirmations

3.3 V Connection to ADC_VREF When Replacing a MAX 10 SC Device with an SA Device

Schematics/layout for TerasIC SoCKit rev. D with Cyclone V

Agilex 3 PLL in Source Synchronous mode ?

Cyclone 4 PS Configuration Timing Parameters