Forum Discussion

Junmo's avatar
Junmo
Icon for New Contributor rankNew Contributor
4 years ago

Error coccured during modelsim simulation

I have training board with a cyclone II device. so I have to use quartus II 13.0 sp1 sw. I installed the sw, and coded the circuit using verilog HDL. But during simulation in VWF , the a...
RichardT_altera's avatar
RichardT_altera
Icon for Super Contributor rankSuper Contributor
4 years ago

I have yet to receive any response from you in regards to my last reply.

With that, I will now transition this thread to community support. If you have a new question, feel free to open a new thread to get the support from Intel experts. Otherwise, the community users will continue to help you on this thread. Thank you.

Best Regards,

Richard Tan

p/s: If any answer from the community or Intel Support are helpful, please feel free to give best answer or rate 9/10 survey.