Forum Discussion

NYup's avatar
NYup
Icon for New Contributor rankNew Contributor
6 years ago

Error (209014): What is the problem?

I am using Quartus version 18.0 on linux. FPGA MAX10 device number 10M08SAM156CBG I programmed the same image yesterday. It was fine.
NYup's avatar
NYup
Icon for New Contributor rankNew Contributor
6 years ago

CONF_DONE pin failed to go high in device 3.

I have secure_jtag enabled.

I could load the image yesterday. I had pin to bring out FSM of the secure-jtag block that I got from Intel.

so I change the image to look at different internal signals.

Today, I can't erase, can't load .sof or .pof.

Please help