EPM7128AETC100-10 RoHS, sDoc, MD requirement, and reliability report support.

Question

Hi,
I am looking for EPM7128AETC100-10 RoHS, SDoC(supplier declaration of compliance), MD(material, declaration), and document of plating&amp;reflow. Could you please support these to me. I found the MD online, but it is an xml file that i cannot read it.

At same time, i am looking for the reliability report for both EPM7128AETC100-10 and EPM7128AETC100-7N.

Thanks,
Shu

aqidayman_altera · Answer

Hi Shu,Thank you for reaching out to Intel FPGA Community.Regarding your request, EPM7128AETC100-10 and EPM7128AETC100-7N are being discontinued. You can refer Product Discontinuance Notification (PDN2041) here: Intel® FPGA PCNs, PDNs, and ADVsHence, I have limited source to get all the documents requested.However, for the RoHs you can refer here Does Intel® FPGA comply with Restrictions of Hazardous SubstancesThe recommended reflow process you can refer here FPGA Package and Mechanical: Guidelines and Specifications by downloading AN353: SMT Board Assembly Process recommendations (Legacy Products).

aqidayman_altera · Answer

For the material declaration, you can refer to the attached document.

Regards,
Aqid Ayman

shu2 · Answer

Hi,
Thank you very much. Do you konw where i can downlaod the reliablity report of -7N and -10 chips? I know the chips are being discontinued. But we still have some -10 stock now. I need to prove the -10 reliablity is same as -7N, so we can use any one in our product.
I tried to find the reliability report, but it always put me into below website. i cannot find it.
https://www.intel.com/content/www/us/en/support/programmable/support-resources/quality/capabilities.html

Regards,
Shu

aqidayman_altera · Answer

Hi Shu,Usually the reliability report can be downloaded from Resource &amp; Documentation Center but you will need a Corporate Non-Disclosure Agreement (CNDA) to be able to download it. However, for the older devices like you requested will be not available in the the link given.Do you have the CNDA? If yes, you can provide to me through private message and I will procced to retrieve the reliability report for you from internal team.

shu2 · Answer

Hi,
I got the CNDA. How could i contact you through private message.

Forum Discussion

EPM7128AETC100-10 RoHS, sDoc, MD requirement, and reliability report support.

7 Replies

Recent Discussions

Agilex 7 R-Tile RBES FPGA – CXL Device Enumeration Failure with CXL IP Design Example

Agilex 7 R-Tile RBES FPGA – Board Fails to Power On and JTAG Not Detected

Agilex 7 R-Tile R1BES FPGA – CXL Device Enumeration Failure with CXL IP Design Example

LVDS SERDES rx_inclock idle

Max10 Security Bit