Forum Discussion

Honored Contributor

17 years ago

EP3S150ES VCC/VCCL Resistance to ground

Hi All: We just got a board back, and we are seeing an oddity on the 1.1V supply. We haven't powered the board yet, because of this. Right now we are seeing ~3-4 Ohm resistance to gro...

Altera_Forum

Honored Contributor

12 years ago

Double check you have the JTAG hooked up to the proper supplies. Some pins need to be tied to VCCPGM and some to VCCPD on the stratix III

http://www.altera.com/literature/hb/stx3/stx3_siii51011.pdf

Check out page 11-39 in the handbook

Pete

Forum Discussion

EP3S150ES VCC/VCCL Resistance to ground

Recent Discussions

Bidirectional pin USB_RX with a pseudo-differential I/O standard must use the OEIN port of the node

Avalon-ST configuration with Agilex 3 fails

Trouble Getting started with Stratix 10 SOC

Obsolescence issues

Request for COO info