Forum Discussion

WLin30's avatar
WLin30
Icon for New Contributor rankNew Contributor
4 years ago

Does the ddr3 descrete components' command & address signals need termination resistors for c10?

I have design a board c5+descrete ddr3 component which command & address signals do not have termination resistors which run ok. I am not sure wheter C10 also ok for such design.
WLin30's avatar
WLin30
Icon for New Contributor rankNew Contributor
4 years ago

Do you mean that by setting Cyclone10's OCT/ODT that need not external termination resistor?

WLin30's avatar
WLin30
Icon for New Contributor rankNew Contributor
4 years ago

If yes, how to set the EMIF's parameters?