LaWe
New Contributor
New ContributorDE2 Board won't start
Hi,
I have an old development board (DE2 cyclone II FPGA) but after the power button is pressed it gets stuck in a state(attached picture shows this) this happens in RUN mode but it acts normal(I t...
Hi,
You will need to change the SW19 switch to PROG position so that it is power up and configured through EPCS flash.
Please refer to https://www.terasic.com.tw/cgi-bin/page/archive_download.pl?Language=English&No=502&FID=cd9c7c1feaa2467c58c9aa4cc02131af
