Forum Discussion

zhangxianyu's avatar
zhangxianyu
Icon for New Contributor rankNew Contributor
10 months ago

DDR3 uniphy init fail,please help

我的 DDR3 PCB 板初始化失败，phy_cal_debug_info==257，我启动了 memory toolkit，它显示验证失败。现在，在使用掩码功能后，验证再次成功。我应该怎么做才能确保我的 DDR3 正常运行 我的 DDR3 芯片上的所有信号长度相等 My DDR3 PCB board initialization failed, phy_cal_debug_info...
Board Debug
zhangxianyu's avatar
zhangxianyu
Icon for New Contributor rankNew Contributor
10 months ago

Thank you for replying to me

this is my project

The hardware was drawn by my colleague, and the control lines are not of equal length. The others are of equal length. Currently, I don't know if it's a hardware or software issue. How can I debug to see the timing of DDR3 operation