Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
8 years ago

Cyclone IV IBIS Model

Hi, i'm performing a board simulation that use a Cyclone IV FBGA-484. I need to simulate an address line (50 ohm impedance trace) from FPGA (pin A9 - IO/DIFFIO_T24n) to an SRAM. The VCCIO is 3.3V ...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
8 years ago

Hi

Yes you need to model with OCT.

You can download the package model specific to the device from website or generate the PIN based model using quartus tool.

Check the linkhttps://www.youtube.com/watch?v=izcvszgu2ws

https://www.youtube.com/watch?v=46kj1yr2-z4

For simulation the link

https://www.altera.com/support/support-resources/download/board-layout-test/ibis/ibs-about_ibis.html

Best Regards,

Anand Raj Shankar

(This message was posted on behalf of Intel Corporation)