Forum Discussion

New Contributor

4 years ago

Cyclone III Programs, Doesn't Boot

I have two boards with Cyclone III FPGAs that appear to program and verify properly but it doesn't boot. It has activity LEDs that turn on, showing that it is doing something but not operating as it...

NurAiman_M_Intel

Super Contributor

4 years ago

Hi,

Thank you for contacting Intel community.

Please clarify;

What Quartus version that was used?
What type of configuration was used? Active seria, Passive serial, etc..
Have you refer to Cyclone III device handbook for further information?

https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/hb/cyc3/cyclone3_handbook.pdf

Regards,

Aiman

Forum Discussion

Cyclone III Programs, Doesn't Boot

Recent Discussions

Question

Will serialization factor of 6 in LVDS serdes IP be supported in the future on Agilex5?

1.8 V LVDS Receiver Timing Specifications for Intel MAX 10 Dual Supply Devices

Avalon-ST configuration with Agilex 3 fails

Quartus Prime Pro 25.1 fatal error during fitter: Windows "Efficiency mode" required