Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
17 years ago

Cyclone III EPCS16 config FAIL

Hi all, I'm working on a revision of a PCB that contains a total of 12 EP3C16Q240C8N all configured with the same object file as in figure 10-6 of the datasheet. As it stands now, the configur...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
17 years ago

--- Quote Start ---

Hi All,

i have 10K Pullup to 3.1VCC (3.1VCC for all Banks) up for config_done and n_status. Also an pulldown 10K for nCe.

MSEL is switch to AS. No Problems. Programming over JTAG with *.jic also no Problem.

Your MSEL are right?

It is also possible what Jay Vicory think, it is a problem of a charge of series production?

regards

Michael

--- Quote End ---

what is *.jic file?

my sycloneIII JTAG Configuration has some problem.