Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
9 years ago

Cyclone III Configuration Problem

I completed a design using a Cyclone III EP3C5F256C8N back in 2013. We have been shipping the board with no problems until now. The last batch of 50 boards we built all have the same problem, in whic...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
9 years ago

The fact that CONF_DONE never goes high, even before configuration starts, may indicate a problem with the CONF_DONE pullup. It does not look like you're stuck in POR because nSTATUS is held low during POR and that is not happening.

Do you have a JTAG connector on the board? If so, it would be interesting to know what Quartus sees in the JTAG chain.