Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
8 years ago

Cyclone III - how to reconfigure from one application image to another?

I have EPCS chip attached to FPGA, and have several images in it. Factory is at 0, loaded on power up. Then factory image automatically loads image located at page 8. It works properly. For this I ju...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
8 years ago

Information about next image to load has to be written into configuration controller register and is retrieved during reboot, review device handbook and application notes.