Forum Discussion
Altera_Forum
Honored Contributor
Honored ContributorCyclone II LVDS termination on DE2
hey guys, I the plan is to use the Terasic DE2 LVDS lines to receive serial data from an ADC. The Cyclone II device handbook (figure 11-3) says that the LVDS receiver line should terminate with...
Altera_ForumHonored Contributor
Honored ContributorHi,
Just to add that you should take note that with soldered resistor, the signal integrity might not be as good as originally mounted resistor. In case you observe degraded signal integrity, this could be one of the possible root cause during debug.
