Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
16 years ago

Cyclone 3 PS configuration problem

Hello, I am trying to configure a cyclone 3 using passive serial mode and arm9 (in a driver in WinCE6.0). At first I check if nStatus is low (FPGA in reset) and it is. Then, I put nCON...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
16 years ago

Solved. Reason was that not all FPGA voltage supplies were active.